Gripdeck Primecoat E is designed to give excellent adhesion to both the substrate to which it is applied and the subsequent Gripdeck Flexcoat coating.

Materials Supplied

5kg and 20kg. 

Coverage

The coverage will vary depending on the texture of the surface to which the Gripdeck Primecoat E is applied. As a guide, the coverage is approximately 0.4kg/m² depending on the above and the requirements of the specification.

Storage

Store under dry warehouse conditions at temperatures between 10°C and 30°C.

Shelf Life

12 months if unopened, undamaged,

Technical Information

Gripdeck Primecoat E comprises two components, a Resin Base and Hardener which are supplied pre-weighed in the correct proportions. Under no circumstances should part mixing be carried out.

Taking care to ensure that the bottom and sides are thoroughly drained, pour the contents of the hardener portion into the resin container. Using a power whisk attached to a slow speed electric drill, mix for approximately 2 minutes followed by scraping down and re-mixing for a further 1 minute avoiding the entraining of excessive air until a uniform consistency is obtained and allow to stand for 1 minute. The addition of a dry fine sand may be added at this stage to help smooth the substrate.

Never mix Gripdeck Primecoat E by hand as this could lead to areas of uncured material.

APPLICATION

Once mixing is complete, spread the Gripdeck Primecoat E onto the floor using a squeegee and short / medium pile roller, ensuring it is worked well into the surface.

Gripdeck Flexcoat should be applied to the cured Gripdeck Primecoat E, this should be undertaken within 30 hours of application.

CLEANING

Tools should be cleaned with solvent immediately after use.

HEALTH AND SAFETY

Consult the appropriate Material Safety Data Sheets prior to using Gripdeck Primecoat E.

GENERAL GUIDANCE

This data sheet is for general guidance purposes only and may contain information that is inappropriate for certain conditions of use. Accordingly, all recommendations and suggestions are made without guarantee. Further information is available from our Technical Department.