Setseal 6 has been designed to overcome the drawbacks of many commonly used curing membranes which tend to provide a limited service life following the curing period of new concrete. It has good abrasion resistance and can be coated with certain coatings (please contact our Technical Department for specific applications).

Materials Supplied

25 litres and 200 litres.

Coverage

5 - 12m² per litre per coat depending on the absorbency of the base.

Storage

Store in closed containers above freezing (0°C) under dry, well ventilated warehouse conditions out of direct sunlight and away from naked flames or other sources of ignition

Shelf Life

At least 12 months if stored in original containers.

Technical Information

Stir the Setseal 6 before use.

Apply Setseal 6 by fine spray at a rate of 5 to 12 m² per litre. In severe drying conditions a second coat should be applied after 2 to 3 hours. Care should be taken to ensure complete coverage.

OLD CONCRETE

Apply Setseal 6 by squeegee, brush, spray or broom at a nominal rate of 5 to 10 m² per litre for the first coat, followed 5 to 8 hours afterwards by a second coat of 10 to 12 m² per litre.

As the condition and therefore the porosity of concrete surfaces can differ so widely, it is recommended that a test application area be carried out to determine the precise coverage rate for each specific job.

All equipment and tools should be cleaned thoroughly with Xylene and allowed to dry.

OVERCOATING

Please contact our Technical Department for specific applications.

WORKING CONDITIONS

Application range 5°C to 30°C.

Do not apply in external situations where rain is likely to come into contact with the uncured Setseal 6.

HEALTH AND SAFETY

Refer to the product Material Safety Data Sheets before using Setseal 6.

GENERAL GUIDANCE

This data sheet is for general guidance purposes only and may contain information that is inappropriate for certain conditions of use. Accordingly, all recommendations and suggestions are made without guarantee. Further information is available from our Technical Department.